Safety Precautions - BDS Maschinen MAB 485 Mode D'emploi

Preparations

Safety precautions

MK tool mounting
48
All manuals and user guides at all-guides.com
WARNING
Risk of injury!
► Do not use damaged, soiled or worn tools.
► Carry out tool changes only when the machine is switched
off and at a standstill. Remove plug from the mains socket.
► After inserting, check that the tool is engaged securely.
► Only use tools, adapter and accessories that match the
machine.
Inserting the tool
Before mounting, clean the shank of the tool, adapter or drill
‹
chuck and the morse taper (3) of the machine.
Push the tool from below into the morse taper (3) of the
‹
machine.
WARNING
Risk of injury from incorrectly inserted tool!
► Check the proper seating of the tool, adapter or drill chuck in
the MK tool mounting.
Removing the tool
Turn the tool until the ejector pin (E) slips into the opening for
‹
the ejector pin (4).
Prise out the tool with the ejector pin (4) or loosen the tool by
‹
tapping against the ejector pin.
MAB 485