BDS Maschinen MAB 485 Mode D'emploi page 47

Steel of low thickness
NF metals or workpieces with an uneven surface
Inserting the tool
MAB 485
All manuals and user guides at all-guides.com
When drilling in steel of low thickness, an additional steel plate
(minimum dimensions 100 x 200 x 20 mm) must be placed under
the workpiece. Secure the steel plate to prevent it from falling.
A special holding device must be used when drilling in NF metals
or in workpieces with an uneven surface.
NOTE
► BDS offers special clamping devices for tubes and non-
magnetic materials in its range of accessories.
The machine is equipped with an MK tool mounting. Depending
on the type of tool to be used, corresponding drill chucks, quick-
clamping systems or adapters must be employed.
Tool
Tool with
taper MK
Tools with
19 mm Weldon shank
Tools with
straight shank
Thread taps
Tool mounting to be used
Insert the tool directly into the morse taper
(3).
Use KEYLESS quick-change drill chuck
system (A).
Use key-type drill chuck (H) with tapered
mandrel MK2/B16 (F).
Use KEYLESS quick-change drill chuck
system (A) with the appropriate adapter
(G) for thread taps.
Preparations
47