Haussmann XTCD-14 Guide De L'utilisateur page 10

IMPORTANT SAFETY INSTRUCTIONS
9. ALWAYS CHECK THAT ADJUSTING KEYS AND WRENCHES ARE REMOVED
FROM THE TOOL OR MACHINE WORK SURFACE BEFORE USING THE
TOOL.
10. DON'T FORCE THE TOOL. It will do the job better and more safely at the rate for
which it was intended.
11. REPLACEMENT PARTS. When servicing, use only identical replacement parts.
12. CHECK FOR DAMAGED PARTS. Before using any tool, any part that appears
damaged should be carefully checked to determine that it will operate properly and
perform its intended function. Check for alignment and binding of all moving parts,
broken parts or mounting fixtures and any other condition that may affect proper
operation. Any part that is damaged should be properly repaired or replaced by a
qualified technician.
SPECIFICATIONS
Blade size: Φ7/8" X Φ1/4" X 5/64" (Φ22 X Φ6 X 2 mm)
Base size: 21-1/4" X 6-5/8" X 3/4" (540 X 168 X 20 mm)
Max cuting depth: 1/2" (12 mm)
Max cutting length: 14" (350 mm)
OPERATION
WARNING! ALWAYS USE SAFETY GLASSES. Everyday eyeglasses only have
pact-resistant lenses – they are not safety glasses.
RIP CUT
Place the tile at the front edge against the front stop. (See "RIP CUT" on the right).
Position the tile so the line of cut is directly over the scoring line, which is the line
between the left and right pad (See "Scoring Line" on the right). Place the table
extension arms under the tile for the best possible support. Adjust the cutting
guide by loosening the guide knob (See "Slide Rule Guide Knob" on the right) and
sliding it left or right to the desired cutting position, and lock the cutting guide in
place.
10
XTCD-14
All manuals and user guides at all-guides.com
!