FACTO 83035008 Guide De L'utilisateur page 7

WARNING
l
Risk of electric shock - This pump is supplied with a grounding
conductor and grounding type attachment plug. To reduce risk of
electric shock, be certain that it is connected only to properly
grounded, grounding-type receptacle.
l
To reduce the risk of electrical shock, use only on portable
self-contained fountains no larger than 5 feet in any dimension.
l
Risk of electric shock - do not remove cord and strain relief. Do not
connect conduit to pump.
l
This pump has been evaluated for use with water only.
l Risk of electric shock – this pump has not been tested for use in
swimming pool or marine areas.
l
Do not connect to any voltage other than that shown on the pump.
l
Always disconnect pump from electrical outlet before handling it or
moving it.
l
Don't operate without water.
l
Operate pump completely submerged for proper cooling.
PERFORMANCE
A clogged or dirty intake screen will greatly reduce performance.
If the pump is used on a dirty surface, raise it slightly to reduce the amount of debris contacting the intake.
If less flow is desired, adjust the flow control lever on the side of the pump or restrict the discharge flow.
Do not let the pump run when not submerged in water. Doing so may damage the pump. Always
submerge the pump first, and then plug in the electrical outlet. The pump might run dry the first few
minutes because there is air in the pump and the tube. This is normal. Please unplug and re-plug pump
several times, it will work properly after a few minutes.
The pump is to be supplied through a residual current device (RCD) with a rated residual operating
current not exceeding 30 mA.
MAINTENANCE
To clean the pump, remove the back cover and the impeller.
Use a small brush or stream of water to remove any debris.
CAUTION: The pump shaft cannot be removed.
IF THE PUMP FAILS TO OPERATE, CHECK THE FOLLOWING:
l
Check the circuit breaker and try another outlet to make sure the pump is getting electrical power.
NOTE: Always disconnect pump from electrical outlet before handling it or moving it to another
location.
l
Check the pump discharge and tubing for kinks and obstructions. Algae build up can be flushed out
with a garden hose.
l
Check the inlet to ensure it is not clogged with debris.
l
Remove the pump inlet to access the impeller area. Turn the rotor to ensure it is not broken or
jammed.
l
Monthly maintenance will increase your pump's life.
NOTE: Ensure that the electrical cord loops below the electrical outlet to form a "drip loop". This will
prevent water from running down the cord into the electrical outlet.
PDF 文件使用 "pdfFactory Pro" 试用版本创建
All manuals and user guides at all-guides.com
Page 7
www.fineprint.cn