FACTO 83035008 Guide De L'utilisateur page 5

ASSEMBLY INSTRUCTIONS
Step 1: Remove the product (A) from the box; place the fountain onto level surface.
Step 2: Connect PVC plastic tube (E) to the outlet nozzle of pump (B) and put them (B&E) inside the base
(F) align smoothly through the back open slot (G). Pay attention to have the power cord (D) pass
through the outlet hole (I).
Step 3: Attach the cover plate (C) to match the back open slot.
Step 4: Fill the water tank (K) with clean water (H). Make sure the pump (B) is completely submerged in
water. The fountain is completely assembled as shown in Fig.3. In order to have best effect, the
water level should be ¾ inch (2 cm) below the water tank tip (J)
Step 5: Use proper power supply and plug the pump power cord (D) to the outlet to run the fountain. In
case of uneven water flow, plug and unplug the pump 3-4 times to clear any air that may have
been trapped.
Reverse the steps in the assembly instructions to replace the pump (B).
Be careful not to spill water onto the plug of the pump.
DO NOT allow the pump to run dry!
TROUBLESHOOTING
1. If your FOUNTAIN PUMP fails to operate, please check the following:
a) Make sure the pump is plugged into the socket properly.
b) Check the water level in the fountain. Running the pump without sufficient water can damage the
pump.
c) Check the setting of the flow control on the pump. Check the pump outlet nozzle and PVC
plastic tube for dirt and debris. Clean if necessary.
d) Make sure the pump is connected to PVC plastic tube tightly. Check the fountain tubing for kinks
and obstructions (refer to assembly step 3).
e) The pump may be "air locked". Plug and unplug the pump several times to clear any air that may
have been trapped.
2. If the water does not flow out of the fountain, it may be caused by a kinked or loose PVC plastic
tube, make sure PVC plastic tube is connected properly.
PDF 文件使用 "pdfFactory Pro" 试用版本创建
All manuals and user guides at all-guides.com
Page 5
www.fineprint.cn