Audizio RP320 Manuel D'instructions page 5

CAUTION! Immediately upon receiving the product, carefully unpack the carton, check the contents to ensure that all parts
are present, and have been received in good condition. Notify the shipper immediately and retain packing material for
inspection if any parts appear damage from shipping or the package itself shows signs of mishandling. Save the package and
all packing materials. In the event that the product must be returned to the factory, it is important that the product be
returned in the original factory box and packing. If the device has been exposed to drastic temperature fluctuation (e.g. after
transportation), do not switch it on immediately. The arising condensation water might damage your device. Leave the device
switched off until it has reached room temperature.
1. Tone-arm clip
This specially designed arm clip secures the tone-arm while at rest or when not
in use. The arm clip has been designed to remain in the up position while
unlocked.
2. Autostop Switch ON/OFF
This switch turns auto stop on or off. When the automatic stop is enabled, the
platform will start rotating as soon as the tone arm is placed over the record and
will stop rotating when it has reached the end of the record. Some vinyl records
stop before the end or do not stop when the end is reached. In this case set Auto-
stop function to OFF.
3. Speed button
This switch controls the RPM (33/45/78rpm) of the record player platter.
4. Pitch control
Turn to adjust the speed of the platter little by little.
5. Function knob
Knob to select phono- or BT-mode.
6. Power/volume knob
Turn the knob to turn on/off- and set the volume of the turntable.
7. Headphone jack
3.5mm jack for connecting headphones.
8. Cartridge with needle
When the turntable is not in use, it is recommendable to place the removable
protection cover over the stylus.
9. RCA line output
The sound signal from long-playing record is sent to this line output. Connect this
signal to the line input of an such as an amplifier or a line input of a CD/DVD
player.
10. AUX input
Connector for auxiliary input.
11. USB port
Use a USB cable to connect your turntable to your computer. The USB connection will send audio from the turntable to
your computer.
12. DC input
Connect the power adapter.
13. Speakers
1. Connect the record player with the power adapter and plug the other end into a wall power outlet.
2. Gently remove the protective needle cover.
3. Turn the power & volume control knob clockwise to turn on the record player.
4. Select phono mode by turning the function knob to PH.
5. Place a vinyl record on the turntable platter and select the desired speed (33/45/78RPM) according to the record.
6. Open the tone arm clip to release the tone arm. Push the lift lever backwards to raise the tone arm and gently move the
tone arm to the desired position over the record. The turntable will begin to spin when the tonearm is moved towards the
record (when the AUTO STOP switch is ON). Push the lift lever forwards to lower the tone arm slowly onto the desired
position on the record to start playback.
7. Turn the volume control knob to adjust the volume.
8. Adjust the pitch control knob to adjust the speed gradually.
Noted: If the AUTO STOP ON/OFF Switch is turned ON, the record will stop automatically when finished. If Auto Stop Control
is turned OFF, record will NOT stop automatically when finished.
5