Light-N-Carry LNC1841 Manuel De L'opérateur page 6

OPERATING INSTRUCTIONS
Do not turn on the work light while it is being charged.
Direct the lens away from your eyes before turning on the
work light.
Press the POWER button to achieve the operational mode
desired:
– Press POWER for COB Work Light low brightness mode.
– Press POWER a second time for COB Work Light high
brightness mode.
– Press POWER a third time for Focus Beam Light mode.
– Press POWER a fourth time to turn the unit OFF.
NOTE: All light operating modes are adjustable. When in
any light operating mode, hold down the power button.
The light will flash twice and begin to dim until it reaches the
lowest setting and then begin to increase again.
The unit incorporates a rotating arm with an integrated mag-
net in its base for ideal positioning, allowing it to be attached
to any ferrous metal surface. In addition, the unit has dual
magnets and hooks for mounting on the rear of the unit.
Recharge the work light after use, and at least every 3
months when not is use.
6