Hayward ZRD Série Manuel D'installation page 9

Paragraph 8 – Flow Calibration
Programming
PROG
-­‐
-­‐
Pump Calibration
0,23 cc/stroke
Pump Calibration
Pump Calibration
cc/stroke
Manual
-­‐
Automatic Cal.
Pump Calibration
Start 100 strok.
Automatic
-­‐
Automatic Cal.
Strokes
ml
Paragraph 9 - Statistics
Programming
PROG
-­‐
-­‐
Statistic
Hours 10
Statistic
Strokes 1000
-­‐
Statistic
Q.ty(L) -­‐ 100
Statistic
Power -­‐ 10
Statistic
Reset
ESC
Statistic
-­‐
Hours 10
Paragraph 10 - Password
Programming
PROG
-­‐
-­‐
Password
****
Password
0000 -­‐
Hayward Flow Control
-­‐
+
0,23
100
-­‐
Automatic Cal.
+
20
-­‐
Statistic Reset
+
NO
-­‐
+
www.haywardflowcontrol.com
The memorised cc value per strike appears in the main
menu. It can be calibrated in two different ways:
MANUAL – manually enter the cc value per strike using the
keys and confirm by pressing the
AUTOMATIC – the pump makes 100 strikes, which are
started by pressing the
enter the quantity sucked up by the pump using the
keys and confirm by pressing the
The entered figure will be used in flow calculations.
The main menu displays the pump operation times. By
pressing the key you can access other statistics:
- Strokes = number of strokes made by the pump
- Q.ty (L) = quantity dosed by the pump in litres; this figure is
calculated on the basis of the memorised cc/stroke value
- Power = number of pump starts
- Reset = use the
otherwise (NO), then confirm by pressing the
Pressing the key will take you back to the main menu.
By entering the password, you can enter the programming
menu and see all the set values. The password will be
requested whenever you seek to modify them.
The flashing line indicates the number than can be modified.
Use the key to select the number (from 1 to 9), and the
key to select the number to be modified. Confirm by
pressing the key. By setting "0000" (default), the
password is eliminated.
Operation
key
key. At the end of this process,
key.
Operation
to reset the counters (YES) or
Operation
1-888-INDL (1-888-429-4635)
Pg. 7 of 11
key.
ZRDIOM