Safety Instructions; Proper Use - Heitronic 36384 Instructions D'installation Et D'utilisation

GB Installation and Operating Instructions
LED grave-lamps
Art. No. 36384
These operating instructions solely relate to the product.
They contain important information for the start-up and handling of the lights.
Therefore pay attention to these operating instructions, even if you pass this product on to third
parties.
It is important, therefore, that these instructions are archived carefully for referring to information at a
later stage.
1. Introduction
Dear customer, thank you for deciding to purchase our product.
You have acquired a product from Vollmer, which has been built according to the current state of technology.
The solar light fulfils the requirements of effective European and national guidelines.
To maintain the condition of the product and to ensure safe operation, you - as the user - must observe the
instructions of this operation manual!

2. Safety Instructions


In the event of damage which is caused by not following these operating instructions,
the warranty is rendered void.

We do not accept liability for any consequential damage!

Do not allow the light to come into contact with extreme heat or naked flames.

We do not accept any liability for damages to property or personal damages caused by incorrect handling
or failure to observe the safety instructions.

In such cases, all warranty claims are rendered void.

The product in its entirety must not be altered or modified. Alterations to the product invalidate the guarantee.

The type plate must not be removed.

3. Proper Use

The light is designed for use in outdoor areas.
A high performance light diode (LED) is used as the source of light.
This LED grave-lights guarantees high light intensity with low power consumption.
4. Commissioning
1. Remove the light from the packaging carefully.
2. Observing the safety and warning instructions, place the light in the required
position and press the switch. (Remove the lamp cover).
3. It is not possible to replace the lamp.
4. The type plate must not be removed.
1 of 2 | Dated 18.04.2018