Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
TECHNICAL
CHARACTERISTICS
Voltage ..................................See data plate
Motor power .....................................1200 W
Sound level ....................................60 dB(A)
Depression ....................................240 mbar
Useful capacity tank ............................... 11 l
Detergent tank capacity ........................... 7 l
Dimensions ...............530 x 380 x 485H mm
Weight .............................................. 10.5 kg
Accessories ................................... Ø 36 mm
INTRODUCTION
DANGER:
Before using the appliance please read the
booklet "SAFETY INSTRUCTIONS FOR
FANS" attached to this.
This manual forms an integral part of the
machine itself. It must therefore be kept in
a safe place where it is accessible to all us-
ers (operators and maintenance personnel)
throughout the life of the machine until it is
scrapped.
TYPE OF USE
This appliance was designed for spray wash-
ing and extracting any type of fabric, carpet,
car seats, floors etc.
It can be used as a vacuum cleaner and or
solid and liquid suction unit with the appropri-
ate accessories upon request.
It has only been designed for these uses.
DANGER:
The manufacturer can not be held respon-
sible for any damage due to improper or
incorrect use.
Any other use releases the manufacturer
from liability for harm to persons and/or
property and invalidates any warranty
condition.
IMPROPER USE
Do not use the appliance to:
-
Aspirate flammable, explosive, corrosive
and toxic substances.
-
Aspirate hot substances.
-
Do not use the appliance in liquid suction
mode to suction powder and vice versa
Do not use the appliance in areas at risk of
explosion.
PREPARING THE
APPLIANCE
Assembling the hoses
-
Insert, as far as possible, the sleeve (1
Fig. 1) of the suction hose into the nozzle
(2 Fig. 1) on the drum.
-
To release the sleeve (1 Fig. 2) move the
lever (3 Fig. 2) clockwise then pull the
sleeve outwards (1 Fig. 2).
-
Connect the (4 Fig. 3) detergent delivery
hose to the quick coupling (5 Fig. 3); to
release it push the quick coupling (5 Fig.
3) inwards.
-
Connect the detergent suction (6 Fig. 4)
hose to the quick coupling (7 Fig. 4); to
release it push the quick coupling (7 Fig.
4) inwards.
Rigid pipe assembly for washing
carpets or floors (if present)
After connecting the suction hose to the out-
let the drum, do as follows:
-
Make sure the lever (8 Fig. 5) is in verti-
cal position then attach the first extension
(10 Fig. 5) to the ergonomic handle (9
Fig. 5) of the flexible hose and lock it in
place by turning the lever (8 Fig. 5) to the
horizontal position.
-
Attach the first extension (10 Fig. 6) to the
second extension (11 Fig. 6) and lock it
in place using the lever (12 Fig. 6) as de-
scribed previously for the first extension.
-
Attach the floor nozzle (13 Fig. 7) to the
second extension (11 Fig. 7) and lock it
in place using the lever (14 Fig. 7) as de-
scribed above.
EN - 1
Publicité
Table des Matières
