Spare Parts - Ghibli & Wirbel Power Extra 11 Utilisation Et Entretien

www.ghibliwirbel.com
Professional Cleaning Machines Since 1968
Periodic checks
Checking and cleaning the motor
protection filter
- Remove the cylinder head as previously
indicated.
- Remove the filter (41 Fig. 22)
- Wash the filter (41 Fig. 22) with warm
running water removing all foreign par-
ticles and reassemble only after a thor-
ough drying.
- Insert the filter (41 Fig. 22) on the motor
hood then through the straps (36 Fig. 22)
hooking the elastic part on the top of the
filter with washers (33 Fig. 22).
- Reassemble in reverse order.
Cleaning the detergent dispensing
nozzle
If you note that the detergent is not dispensed
evenly, clean the nozzle as described below:
- Remove the ring nut (34 Fig. 23).
- Remove the nozzle (35 Fig. 23) and clean
it with running water, if it is clogged use a
pin being careful not to distort the shape
of the nozzle.
- Reassemble all of the parts performing
these operations in the reverse order.
Cleaning the detergent suction filter
If you note that the detergent is not being
suctioned properly, check and clean the suc-
tion filter located inside the detergent tank.
- Remove the recovery tank as indicated
above.
- Remove the filter (37 Fig. 24) and wash it
under running water; if it is too clogged it
should be replaced.
- Reassemble all of the parts performing
these operations in the reverse order.
Replacing the floor nozzle squeegee
(if present)
If when washing the floors the washing liquid
is not suctioned properly and the floor or car-
pet remains wet, check the condition of the
squeegee (38 Fig. 25).
If the blade is worn or damaged should be
replaced by releasing the blade support (39
Fig. 25) from the nozzle.
When replacing the new blade pay attention
to insert it properly into the mouthpiece, then
press until you hear the click coupling (Fig.
26).
Checking the air outlet filter
- Loosen the screws (42 Fig. 27) and re-
move the cover (43 Fig. 27).
- Remove the wet sponges (36 Fig. 28).
- Clean the sponges with a jet of air (Fig.
29).
You can rinse the filter sponge in warm
water and reassemble only after com-
plete drying; if they are too dirty replace.
- Reassemble all the parts by following the
dismantling process steps in the reverse
order.

SPARE PARTS

Slide nozzle body .................Code 7217519
EN - 5