afx light BEAM1R Manuel D'utilisation page 5

o No DMX signal
o Screen protect
o Open the lamp
o Restore to default settings

MENU setup ( manual control of each DMX channel )

SYSTEM setup
o Software version
o DMX monitor : To see DMX information
o System errors : To see fixture errors
o Total fixture hours : To see used time of fixture
o Partial fixture hours
o Total lamp hours : To see used time of lamp
o Partial lamp hours

ADVANCED setup
o Sensor monitor
o Reset calibration
o Lamp life hours : to see life time of the lamp
o Lamps hours clear

Chinese – English switch

Display screen reverse
2.2 Set up the interface
Option instruction
DMX
Auto1
Run Mode Auto2
Random auto
Sound control
DMX Address 1-512
Channel Mode 12
OFF
X Reverse
ON
OFF
Y Reverse
ON
OFF
X/Y Exchange
ON
KEEP
No DMX Signal
CLEAR
ON
Display screen protect
OFF
Lamp on start up OFF
© Copyright LOTRONIC 2016
All manuals and user guides at all-guides.com
Slave state:Accept control table or main engine
Master State: Auto running and send DMX signal for Slave
Press OK key into edit state, Then selected hundreds place. Press up or
down, change address code. Press OK key again, selected ten place
and edit. Press OK key again, select the first place and edit. Press it to
exit the edit state.
12CH Mode
Change the channel of X/Y axis （include X/Y Fine）
According to the original state continues to run
Motor reset, stop running
Closing backlight after free 30seconds
Backlight still lighting
Reset directly after Power on , lamp off (need to use the menu or control
table to manual let lamp light)
BEAM1R Page 5