Removing/Inserting The Battery; Checking The Charge Status Of The Rechargeable Battery; Recharging The Battery - Grizzly Tools GGBP-20V2AH-GGNE3-P5-QX Traduction De La Notice D'utilisation Originale

GB
Charge the battery in a dry room
only.
Prior to attaching the charger,
check that the battery's outer
surface is clean and dry.
There is a risk of injury due to
electric shock.
Switch off the device and remove
the battery before carrying out any
maintenance work.
• Charge the battery before the first time
of use. Do not briefly recharge the bat-
tery several times in a row.
• Only charge with the originally sup-
plied charger.
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to
be replaced. Only use an OEM spare
battery available from our Customer
Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information.
• The warranty excludes all defects
caused by improper handling.
Removing/inserting the
Battery
1. To remove the battery (4) from the ap-
pliance, press the release button (1)
on the battery and pull out the battery.
2. To insert the battery (4), place it on the
guide track and push it into the appli-
ance. It will audibly snap in.
Only insert the rechargeable
battery once the device is com-
pletely assembled. Risk of in-
jury!
18
Checking the charge status of
the rechargeable battery
The battery charge status indicator (3)
signalises the state of charge of the bat-
tery (4).
Press the button (2) on the battery. The
number of illuminated LED lights shows
the charge level of the battery.
4 lights means battery is fully charged.
1 light means that the battery needs to be
charged.

Recharging the battery

Allow a hot battery to cool before
charging.
Only charge the battery (4) when
the red LED on the charge status
indicator is on.
The charging time is around 1 - 2
hours.
1. Remove the battery (4) from the appli-
ance, as necessary (see „Removing/
inserting the battery").
2. Insert the battery (4) in the charging
compartment of the battery charger (5).
3. Plug the battery charger (5) into a
mains outlet.
4. When the battery is fully recharged
unplug the battery charger (5) from the
mains.
5. Remove the battery (4) from the
charger (5).
Overview of the control display (6) on
the charger (5):
Green LED lights up without battery
inserted: Charger ready.