Functions; Battery Installation - Konect KT25+ Manuel D'utilisation

Functions

KT2S+ Transmitter
Steering Wheel : Control direction (Left / Right) of the RC
Throttle Trigger : Control speed and direction (Forward/Brake/-
Battery Compartment Tray : Cover and hold the batteries powering the
Antenna : Transmit signal to the model
Power ON / OFF : Power ON / OFF the transmitter
SYNC & Battery Indicator : Top Green LED light indicates synchroniza-
ATV : Adjustable Steering Rate by ATV dial
ST. Trim Dial : Adjust the neutral position of steering servo
TH. Trim Dial : Make sure the model stays still when
EPA : End Point Adjustment
WARNING: accidental or intentional EPA function manipulation may
cause servos malfunction (reduced or inexistant travel). Please
reset maximum default values before contacting your dealer
(see ).
5

Battery Installation

Works with 4 x 1.5V AA Install the batteries
Batteries (not provided), observing the polarity
KT2S+ can be operated a marked on battery
few hours. Installation: compartment.
Remove the battery
compartment cover as
shown below.
Warning: Never disassemble batteries or put the batteries in fire, chemical
agents, otherwise they may cause personal injuries or property damages.
Battery Disposal: Observe corresponding regulations about wasted battery
treatment regulations.
1. After running out of power, dispose of wasted batteries in designated areas
far away from water supply, household areas and planted areas.
2. Submit the wasted batteries to specific recycling stations.
TRANSMITTER
model.
Backward) of the driving model.
transmitter.
tion status
and/or adequate battery power supply.
when model wheels are straight ahead.
releasing the throttle trigger.
Then reicompart-
ment cover as the
picture shown
below.
ATV
Power Indicator
Power
ON / OFF
Steering
Reverse Switch
Throttle
Reverse Switch
Steering Trim Dial
Throttle Trim Dial
Battery
Compartment Tray
Battery LED Indicator
- During normal operation, the LED should be solid green ON-
- When battery voltage is dropped below 3.8V, the LED will become red color
and flashing very slowly, to indicate battery is low, you should replace new
battery as soon as possible
Pre-Run Check
LED
LED
Indicator indicator
* Always turn on the transmitter first by sliding the switch on the left side from
bottom to top. The green lights above the switch should light up. If not, you
need to check for low or incorrectly installed batteries.
Antenna
Steering Wheel
Throttle Trigger
BIND / EPA Key
1. Steering : Adjust the steering trim to
keep the front wheels in straight line when
steering wheel remains in NEUTRAL
position.
2. Throttle : Adjust the throttle trim to
ensure the wheels stop rotating when
throttle trigger remains in NEUTRAL
position (only for nitro).
For EP vehicles, this button must be
set to NEUTRAL (calibrate the NEUTRAL
with ESC).
ENG 3