Additional Information - Pioneer DDJ-WEGO Mode D'emploi

Masquer les pouces Voir aussi pour DDJ-WEGO:
Table des Matières

Publicité

For U.S.A. and Canada
The Safety of Your Ears is in Your Hands
Get the most out of your equipment by playing it at a
safe level – a level that lets the sound come through
clearly without annoying blaring or distortion and,
most importantly, without affecting your sensitive
hearing. Sound can be deceiving. Over time, your
hearing "comfort level" adapts to higher volumes of
sound, so what sounds "normal" can actually be loud
and harmful to your hearing. Guard against this by
setting your equipment at a safe level BEFORE your
hearing adapts.
ESTABLISH A SAFE LEVEL:
• Set your volume control at a low setting.
• Slowly increase the sound until you can hear it
comfortably and clearly, without distortion.
• Once you have established a comfortable sound
level, set the dial and leave it there.
BE SURE TO OBSERVE THE FOLLOWING
GUIDELINES:
• Do not turn up the volume so high that you can't
hear what's around you.
• Use caution or temporarily discontinue use in
potentially hazardous situations.
• Do not use headphones while operating a
motorized vehicle; the use of headphones may
create a traffic hazard and is illegal in many areas.
For Canada
This Class B digital apparatus complies with
Canadian ICES-003.
Operating Environment
Operating environment temperature and humidity:
+5 °C to +35 °C (+41 °F to +95 °F); less than 85 %RH
(cooling vents not blocked)
Do not install this unit in a poorly ventilated area, or in
locations exposed to high humidity or direct sunlight (or
strong artificial light)
This product is for general household purposes. Any
failure due to use for other than household purposes
(such as long-term use for business purposes in a
restaurant or use in a car or ship) and which requires
repair will be charged for even during the warranty
period.
WARNING
This equipment is not waterproof. To prevent a fire or
shock hazard, do not place any container filled with
liquid near this equipment (such as a vase or flower
pot) or expose it to dripping, splashing, rain or
moisture.
4
En
WARNING
To prevent a fire hazard, do not place any naked flame
sources (such as a lighted candle) on the equipment.
For other areas
Operating Environment
Operating environment temperature and humidity:
+5 °C to +35 °C (+41 °F to +95 °F); less than 85 %RH
(cooling vents not blocked)
Do not install this unit in a poorly ventilated area, or in
locations exposed to high humidity or direct sunlight (or
strong artificial light)
This product is for general household purposes. Any
failure due to use for other than household purposes
(such as long-term use for business purposes in a
restaurant or use in a car or ship) and which requires
repair will be charged for even during the warranty
period.
WARNING
This equipment is not waterproof. To prevent a fire or
shock hazard, do not place any container filled with
liquid near this equipment (such as a vase or flower
pot) or expose it to dripping, splashing, rain or
S001a_A1_En
moisture.
WARNING
To prevent a fire hazard, do not place any naked flame
sources (such as a lighted candle) on the equipment.
D8-10-1-3_A1_En

Additional information

! For improvement purposes, specifications and design of this unit
About installation locations
! Do not place this unit on objects radiating heat, such as an amplifier,
D3-4-2-1-7c*_A1_En
! Install this unit away from a tuner or a TV. Otherwise, image distor-
Cleaning the product
K041_A1_En
Under normal circumstances, wipe it with a dry cloth. For hard-to-
remove stains, soak a soft cloth in a neutral detergent diluted with 5 to
6 times of water, wring it thoroughly, wipe off the stains, and wipe the
surface with a dry cloth again. Do not use alcohol, thinner, benzene, or
insecticide, as these may peel off the printed label or the coated film.
Avoid leaving rubber or vinyl products in contact for an extended period
of time, as this may also damage the surface of the cabinet. When using
chemical-impregnated wipes, etc., read the cautions carefully.
Unplug the USB cable from this unit before cleaning.
D3-4-2-1-3_A1_En
and the included software are subject to change without notice.
or expose it to a spotlight for an extended period of time, as this may
damage this unit.
tion or noise may result. Also, image distortion or noise can easily
occur if an indoor antenna is used. In such cases, use an outdoor
antenna or turn off the power of this unit.
D3-4-2-1-7a_A1_En
D3-4-2-1-7c*_A1_En
K041_A1_En
D3-4-2-1-3_A1_En
D3-4-2-1-7a_A1_En

Publicité

Table des Matières
loading

Table des Matières