Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
IMPORTANT SAFETY INSTRUCTIONS
18. DISCONNNECT THE PLUG FROM THE POWER SOURCE BEFORE MAKING ANY ADJUSTMENTS, changing
accessories, or storing the tool. Such preventive measures reduce the risk of starting the tool accidentally.
19. STORE IDLE TOOLS OUT OF REACH of children and other untrained persons. Tools are dangerous in the hands
of untrained users.
20. MAINTAIN TOOLS WITH CARE. Keep cutting tools sharp and clean. Properly maintained tools with sharp cutting
edges are less likely to bind and are easier to control. Do not use a damaged tool. Tag damaged tools,
"Do not use" until repaired.
21. CHECK FOR MISALIGNMENT OR BINDING OF MOVING PARTS, BREAKAGE OF PARTS, and any other
conditions that may affect the tool's operation. If damaged, have the tool serviced before using. Many
accidents are caused by poorly maintained tools.
22. USE ONLY ACCESSORIES THAT ARE RECOMMENDED BY THE MANUFACTURER for your model. Accessories
that may be suitable for one tool become hazardous when used on another tool.
SERVICE
23. TOOL SERVICE MUST BE PERFORMED BY QUALIFIED REPAIR PERSONNEL at an authorized service centre.
Service or maintenance performed by unqualified personnel could result in a risk of injury.
24. WHEN SERVICING A TOOL USE ONLY IDENTICAL REPLACEMENT PARTS. Follow instructions in the
maintenance section of this manual. Use of unauthorized parts or failure to follow Maintenance instructions
may create a risk of electric shock or injury.
ADDITIONAL SAFETY REGULATIONS
1. When the machine is in operation, keep hands away from the cutting or grinding area.
2. The disc will not stop immediately the machine is turned off. Exercise caution.
3. Do not place the tool down after use until the grinding or cutting wheel has come to complete stop.
4. Do not start the tool when the grinding or cutting wheel is touching the work piece.
5. Always ensure the safety guard is attached correctly and do not operate the angle grinder without the guard attached.
6. Only use grinding and cutting wheels that are approved for a maximum speed of 13,000 RPM or greater.
7. Only use grinding or cutting wheels with the correct bore size for the spindle of the grinder.
8. Keep the power cord well away from the cutting area during use. Always position the cord so that it will not be caught
in the workpiece when the grinder is in use.
9. Always wear earmuffs, safety glasses and face mask while in operation.
10. Before connecting the tool to the power supply, follow the safety instructions to install the grinding or cutting wheels.
Do not lock the wheel too tight, or cracks may occur.
11. Always use both hands when operating the tool.
12. Use the supplied standard parts. Do not use a coolant or water and do not use as a fixed grinder.
13. ENSURE THE EXTENSION CORD YOU USE IS OF SUFFICIENT GAUGE FOR ITS LENGTH.
AMP
More than
Not more than
0
6
6
10
10
12
12
16
Volts
Total length of cord in feet
120
25
50
Volts
Total length of cord in metres
120
7.62
15.24
Minimum gauge for cord
18
16
18
16
16
16
14
12
100
150
30.48
45.72
16
14
14
12
14
12
Not Recommended
3
Publicité
Table des Matières
