Télécharger Imprimer la page

Executive Audio NSA 2000 Manuel D'utilisation page 11

Publicité

Les langues disponibles

Les langues disponibles

REAR PANEL
17. PHONO INPUT JACKS
Connect turntables equipped with MM pickup cartridge to PHONO inputs (All DJ turntable use MM
pick-up cartridges).The red colored RCA jack represents the right channel input and the white represents
the left channel input.
18. LINE RCA INPUT JACKS
DO NOT CONNECT TURNTABLES TO THESE JACKS! These Jacks are used for line level inputs.
Connect CD players or Tape Decks to LINE inputs. Line level musical instruments with stereo outputs
such as Rhythm Machines or Samplers should also be connected to LINE inputs. Turntables should only
be connected to "Phono" inputs. The red colored RCA jack represents the right channel input and the
white represents the left channel input.
19. GND (GROUD TERMINAL)
Connect each of your turntables ground leads to either of the two ground terminal. This will reduce the
humming and popping noises associated with magnetic phono cartridges.
20. RCA MASTER OUTPUTS
The Master Output includes a pair RCA UNBALANCED JACKS (20). The RCA jacks send a low current
unbalanced output signal.
21. BALANCED XLR MASTER OUTPUTS
The Master Output includes a pair XLR Balanced JACKS as well as a pair RCA UNBALANCED JACKS
(20). The 3-pin XLR jacks send a high current balanced output signal. These jacks should be used when
you will be driving an amp or other audio equipment with a balanced input, or whenever you will be
running a signal line greater than 15 feet. Always, use these jacks whenever possible.
22. 9V AC INPUT
Connect the included power supply to this input, or any other 9V power adapter.
23. MAIN POWER SWITCH
This is the main power ON/OFF button. An L.E.D. located on the MASTER VOLUME LEVEL
INDICATORS (2) of the mixer will glow green when the power is ON. Before main power is applied, be
sure you have made all connections to the mixer. Also be sure your amplifier(s) is (are) tuned off.
Remember to avoid damaging pops, the mixer should be powered on first and turned off last.
24. Input Switch
This switch select between the rear-panel Phono (RIAA) and Line inputs.
All manuals and user guides at all-guides.com
- 11 -

Publicité

loading