Executive Audio NSA 2000 Manuel D'utilisation page 10

11. AUX Input
Input jack for line level input like professional tape machines or effects unit returns.
12. MICROPHONE EQUALIZER
The microphone channel includes a two-band signal EQ. These controls are used to increase or decrease
the LOW's and HI's of the output signal.
MICROPHONE TREBLE CONTROL – This knob is used to adjust the treble levels of the Microphone
with a maximum signal gain of 12dB or maximum signal decrease of -12dB.
Turning the knob in a counter-clockwise direction will decrease the amount of treble applied to the
Microphone signal, turning the knob in a clockwise direction will increase the amount of treble applied to
the microphone signal.
MICROPHONE BASS CONTROL – This knob is used to adjust the low frequency levels of the
microphone with a maximum signal gain of 12dB or maximum signal decrease of -12dB.
Turning the knob in a counter-clockwise direction will decrease the amount of bass applied to the
microphone signal, turning the knob in a clockwise direction will increase the amount of bass applied to
microphone signal.
13. MICROPHONE VOLUME
This knob is used to regulate the microphone output volume. Turning the knob in a clockwise direction will
increase the volume level.
14. TALKOVER CONTROL
This function decreases all signal output except for the microphone signal.
15. MICROPHONE CONNECTOR
This jack is used to connect a microphone to the mixer. Connect you microphone via 1/4 inch (6.3mm)
jack. The signal volume will be controlled by the MIC LEVEL (12). The bass and treble levels can also be
adjusted by the built-in MICROPHONE EQ (13).
16. HEADPHONE OUTPUT JACK
This jack is used to connect your headphones to the mixer allowing you to monitor the cue source. Use
headphones only rated at 8 ohms to 32 ohms. Most DJ headphones are rated at 16 ohm, these are highly
recommended. Always be sure the CUE LEVEL VOLUME (5) is set to minimum before you put the
headphones on.
All manuals and user guides at all-guides.com
- 10 -