Additional Safety Information For Grinders And Polishers; Additional Safety Information For Routers; Operation; Switching On / Off - Parkside PSFS 250 A1 Instructions D'utilisation Et Consignes De Sécurité

Additional safety ... / Additional safety information for routers / Operation
Additional safety information
for grinders and polishers
POISONOUS DUSTS! The working of mate-
rials that can produce harmful / toxic dusts
presents a health risk for the operator and for
people located in the close vicinity.
Avoid sanding of paints containing lead or other
material detrimental to your health.
Do not work on materials containing asbestos.
Asbestos is considered carcinogenic.
Wear safety glasses and a dust protection mask!
Additional safety information
for routers
Hold the device by the insulated handle
surfaces as there is a danger of the
cutter striking the device's mains
lead. Contact with a live wire could cause
metal parts of the device to become live and
lead to electric shock.
Only use cutting bits with the correct size shaft
diameter suitable for the speed of the electric tool.
Fix and secure the work piece to a
stable surface using clamps or other
means. If you only hold the work piece with
your hand or against your body, it will remain
unstable which could lead to a loss of control.

Operation

Never use the device for any purpose other than
the intended purpose and only use it with the origi-
nal parts and accessories. The use of parts or ac-
cessories other than those recommended in the
operating instructions could lead to you suffering
an injury. Use only an extension cable that has
been completely unrolled and is undamaged with
a capacity of at least 5 A.
WARNING: Do not use this tool for the creation
of notches in the vicinity of installations or openings
with live electric cables or in walls behind which
live electric cables could potentially be laid. The bit
could conduct electricity into the tool and this could
involve the risk of electric shock to the operator.
All manuals and user guides at all-guides.com
Attention: Always hold the tool on the plastic
housing and always wear safety goggles when
working with the tool.
Switching on:
Switching off:
Note: Only use combination cutter accessory
parts with a shaft diameter of ø 4.8 mm.
Bits:
The bits included are intended for the following
applications (see Fig. D).
Multi-purpose cutter (HSS)
Application: wood, particle board, plastic
Slot cutter (HSS)
Application: wood, particle board, plastic
Sanding belts
Application: sanding wood
Trigger the circuit breaker or remove the fuse in
order to disconnect the relevant electric circuit.
Switching ON / OFF (see Fig. A)
Press the ON / OFF switch
Release the ON / OFF switch
Setting the speed (see Fig. B)
Turn the speed controller
direction to increase the speed.
Turn the speed controller
direction to reduce the speed.
Changing tools (see Fig. C)
Hold the spindle lock button
Loosen the clamping nut
10
by turning in an anticlockwise direction.
Change the tool.
Block the spindle lock, tighten the clamping
nut using the open-ended spanner
10
:
17
:
16
.
4
.
4
in a clockwise
2
in an anticlockwise
2
pressed down.
11
with the wrench
14
.
14
:
18
GB 39