Lorell 69390 Instructions D'assemblage

Assembly Instructions
Cam Lock Klix Cam
4Pcs + 2 extra Pcs 4Pcs + 2 extra Pcs
STEP 1
STEP 3
IMPORTANT NOTE:
• Place all laminated parts on a clean and smooth surface such as a rug or carpet to avoid the parts from being scratched.
• Check to make sure that you have all parts and hardware.
• Remove all wrapping materials, including staples and packaging straps before your start to assemble.
• Do not tighten all screws/bolts until pieces are completely assembled.
• Keep all hardware parts out of children's reach.
• It is recommended for 2 persons to complete this assembly.
69390/69424/69981, 69391/69426/69982, 69537/69538/69539
Dowel
2Pcs + 2 extra Pcs
Use Cam Cover (I) to cover
Klix Cam (B)
Apply to all
four positions
as shown
Install two each dowels in holes
provided on underside of worksurface.
4 x / "
Screw # 5
8
12Pcs + 2 extra Pcs
Install four each Screw (F) in each
L-Bracket. Install two L-Brackets
COMPLETED ASSEMBLY
Bridge Unit
69556/18217
Cam Cover Screw M6 x 16mm
Flat Bracket
4Pcs + 2 extra Pcs
4Pcs
It is easier if the four each
Flat Bracket (G) are attached
to the desk and credenza
units rather than the
bridge unit first.
24Pcs
STEP 2