Publicité
Adjustment
15)
The first adjustment is the left to right tilt. Refer to figure 13.
By tightening the front screw and loosening the back screw, the
door will tilt out on the left. The reverse is true if you loosen the
front screw and tighten the back screw, the door will tilt out on the
right. Once you get this tilt adjustment correct, tighten the center
screw both top and bottom. Now snap on the logo cap (#4) to
cover this hardware on the top.
See figure 13.
fig. 13
16)
The next adjustment is left to right. Refer to figure 14, loosen
two screws on each T type door mount bracket. Slide the door
left to right so that the overlay is the same on both sides. Tighten
both screws on each bracket. Once this adjustment is final, use
two (#7) screws to lock the door in place.
Install baskets
18)
Install top basket first. Position it inside the frame and
hold it to the top. Snap plastic basket clips (#5) onto the frame
as shown in figure 16. Then slide the basket down on the clips.
19)
Confirm desired spacing, snap in all the clips and attach
remaining baskets.
fig. 16
fig. 14
17)
final adjustment is top to bottom and tilt. Refer to
The
figure 15. Loosen the two M6 (#2) screws. Using the 4mm
allen wrench (#1), tighten the front screw and loosen the back
screw to tilt the top of the door out. If you loosen the front
screw and tighten the back screw, the top of the door will tilt
in. If you need to adjust the whole door down, tighten both
screws the same amount. Finish by tightening the two M6 (#2)
screws.
fig. 15
F
Install remaining door mount bracket(s)
20)
Attach the remaining door mount bracket(s) (E) as shown
in figure 17. The pilot holes you drilled in step 13 should align.
It is important that this door mount bracket fit closely under a
basket so that it does not get in the way of storage.
fig. 17
E
F
Publicité
