Publicité
Door Mounting
9)
The top and bottom of the pantry use the T type door mount
brackets (D). Remove center screw as shown in figure 8, insert
bracket and then connect the bracket to the top of the frame with
center screw. Snug this screw and final door adjustments will be
made later.
10)
Repeat for bottom T type door bracket.
fig. 8
14)
Now you are ready to hang the door. Drive two screws (#6) into only the top two pilot holes per figure 10. Position the door so the screws fit
into the T type door mount bracket (figure 11). Double check to make sure the door is in the correct position, using two #6 screws affix bottom T
door mount bracket to door (figure 12) and tighten top screws.
fig. 10
D
D
fig. 11
11)
Refer to figure 9. The first step is to calculate overlay. Measure
the door and then measure the cabinet opening. Overlay = door
width minus cabinet opening divided by 2. For example; the door is
12 ½" wide, the opening is 12". 12 ½ - 12 = ½", then divide by 2. The
overlay is ¼".
12)
To determine dimensions for "A"
locate your stiles. (Note: Screws need
to install into the meat of the door to
prevent splitting). This will be
dimension "A". Adjust the top T type
door mount brackets so that they will hit
the mounting screws at this dimension.
13)
At this point, lay your door on a
flat surface and mark 6 or 8 pilot hole
locations based on figure 9.
Dimension "B" for face frame cabinet
is 4 ¼" [108mm]. See the table for
dimensions "C" and "D". Use an 1⁄8" drill
bit pre-drill pilot holes.
Face Frame
Frameless
5743
4-1⁄ 4 "
4"
5750
4-1⁄ 4 "
4"
5758
4-1⁄ 4 "
4"
5773
4-1⁄ 4 "
4"
OVERLAY
A
D
C
B
OVERLAY
fig. 9
C
D
N/A
N/A
20-7⁄8" [530]mm
N/A
N/A
N/A
N/A
N/A
fig. 12
Publicité
