Marmitek DOORPHONE 170 Guide Utilisateur page 9

4. Now release the pairing button (7) , press call button (1)
front gate door unit (DO NOT press the call button on the back gate
door unit.). Two "Di Di" sounds will be heard. The screen (17) will
show the following once pairing is successful:
The call indicator (4) on both front gate & back gate door units should
stop flashing and remain steady on.
5. Long press the Power ON/OFF button (15)
handset. Take out the alkaline batteries from the door unit and then
re-install again or connect to the power supply.
6. The doorphone is now ready for operation.
If the pairing process is not successful (the "PAIRING" continues to flash
in the LCD of the handset), repeat the procedures from step 1 again.
N.B. In case you are having two or more handsets as well as a back gate
door unit, always perform the pairing process with all door units and
handsets together and with the handsets being set in pairing mode first.
Remember every time you add on new units to the system, either handset
or door unit (for back gate use), it is necessary to perform the pairing
process all over again with all the units together or otherwise the new
units will not work with your original DoorPhone 170.
DoorPhone 170
on the
(in case there is a
back gate door unit)
to switch off the
9