Handset - Marmitek DOORPHONE 170 Guide Utilisateur

HANDSET

1. The supplied Li polymer battery pack is already installed in the
handset. (To replace, press down the lock button (16) and slide open
the battery door, take out the battery pack and disconnect from the
socket (18).)
2. With the handset remaining switched off, place it onto the charger
stand.
3. Plug in the supplied AC power supply into an AC outlet and connect
its output plug to the USB port (20) located at the back of the charger
stand.
4. The charging indicator (19) should light up red during the charging
process. Adjust the position of the handset in the charger stand in
case this indicator does not light up. During charging, the battery
level icon
will flash in turn.
5. The battery pack should be fully charged within 4 hours when used
for the first time. The power indicator (19) will now go off (if the
handset is switched off) or turn steady blue (if the handset is
switched on)..
6. Now the unit can be switched on and ready for operation. Taking out
the unit or keeping it placed in the charger stand will cause no
damage to the battery. In the latter case, when the battery is being
consumed and the voltage falls to a certain level, the charger stand
will automatically charge up the battery.
DoorPhone 170
TO AC OUTLET
will show up in LCD and the segments inside the icon
7