Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
RU240- page 4
All manuals and user guides at all-guides.com
2 Press
to start the search. Each time the green LED blinks, another
code is sent. When the right code is found, the equipment switches
off (the VCR will stop playing).
3 Immediately press
to stop the search.
If you missed the correct code because the search went too far, switch
the equipment back on, then press
code again. Press
(down) repeatedly until the equipment switches
P
off again.
4 Once you've found the correct code, press
The green LED blinks twice.
That's it! Now, switch the equipment manually on again, then press a
few keys on the remote to check that the equipment responds correctly.
In the rare instance that it doesn't, try again from step 1 to find a better
code.
Note that code! To save time if you ever need to setup again, make a
note of the correct code inside the battery case and in the back of this
booklet. In case you have forgotten to note the code you can still 'read
out' the code from the remote. Here's how:
1 Make sure you've selected the right mode (with
Then press and release
lights up.
2 Press
. The green LED goes out.
3 Press
1
and count the number of times the green LED blinks. This
is the first digit of the 3-digit code. (No blinks means the digit is
zero.)
Press
2
and count the number of blinks for the second digit.
Press
and count the number of blinks for the third digit.
3
ADVANCED TIPS AND TRICKS
TO CHANGE AUDIO MODE TO CONTROL A SECOND TV
The AUDIO mode on this remote is used to control audio equipment. It
is factory preset to control a CD-player, but you can change it to control
a second TV, for example.
Before you start, press
second TV is switched on.
1 Press and hold
and
until the green LED lights up.
2 On the keypad, enter 992.
3 Press
to select TV mode, then press any key except
more. That's it!
Don't forget you now need to setup the remote to operate this second
TV - see Getting started.
TO CONTROL THE SECOND TV'S VOLUME
If you have installed a second TV under AUDIO mode, you can also
control that TV's volume when you are in VCR mode.
4
(down) to send the previous
P
to lock it in memory.
and
at the same time; the green LED
6
to select AUDIO, and make sure the
6
at the same time -for about 3 seconds-
).
once
Publicité
Table des Matières
