Remote Control (Optional); Battery Replacement Transmitter; Cleaning And Service Instructions - Faber GV36FAB Straight Guide De L'utilisateur

UK IRL
2.2.3 Mainburner adjustment
To adjust the flame height turn rotary knob B between the
flame) position
2.3

Remote control (optional)

This version of the remote control is only meant to adjust the height of the flames. It only
functions when the pilot burner is ignited and knob A is in the
Therefore it isn't possible to ignite the pilot flame with the remote control or to extinguish
the pilot flame. The radio-frequency remote control is intended for fireplaces installed in
a domestic setting in all EU countries except Austria, Denmark, Finland and Greece.
2.3.1 Transmission code
The transmission code of the remote control is already set at the factory and can not be
adjusted by the customer.
Adjust the mainburner
First always ignite the pilot light (see 2.1.1 pilot ignition) and turn the rotary knob to the
(large flame) position.
Adjust the fire as desired with the buttons at the remote control (see figure 2.2) :
•
use the button to raise the flames
•
use the button to lower the flames
2.4

Battery replacement transmitter

•
remove the cover on the back of the remote control to access the battery
compartment
•
carefully remove the batteries. Pay attention not to pull the wires
•
replace with one alkaline 9V MN1604 or 6LR61 battery
•
replace the cover
2.5

Cleaning and service instructions

•
Turn off the fire and allow it to cool down before commencing cleaning.
•
It is recommended that the fire is inspected/serviced, by a competent person at
least once a year.
•
To maintain the finish on the trim wipe with soft damp cloth only. Do not use
abrasive cleaners, polish or solvents as these can damage the surface finish.
•
In case of a B1 appliance always sweep the flue at least once a year
9 < < < <
(off) position and (large
(large flame) position.