Handling And Operation; Basic Settings; Setup Menu - Kompernass CR 5 A2 Mode D'emploi Et Consignes De Sécurité

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

All manuals and user guides at all-guides.com
CAUTION
In vehicles in which the cigarette lighter also works with the ignition switched off,
the device must be disconnected from the cigarette lighter socket after use .
Otherwise, the vehicle battery may be discharged over a long period of time,
since the device also uses power when it is idle . The vehicle's engine will no
longer start .
In vehicles in which the cigarette lighter is not switched off, the recording is not
interrupted . In this case, you will need to switch off the camera manually .

Handling and operation

In this chapter you will receive important information for the handling and operation of
the device .
Switching on and off, making settings
Press the on/off
the screen
To switch off the device, press and hold the on/off button

Basic settings

Setup menu

To make the basic settings for the device in the setup menu, press the MENU
button
NOTE
When calling up the menu, you must first press the ▼ button
selection bar on the first entry .
Then you can use the ▲▼ buttons
entry and then call up this menu item with the
menu item without making a change, press the MODE button
current menu board as well as the total number of menu boards is shown . To close
the menu, press the MENU button
CR 5 A2
button to switch on the device . The camera image is displayed on
. The device is now in video standby mode .
followed by the MODE button
. The setup menu opens:
/
to move the selection bar to the desired
/
button
.
for 3 seconds .
Default settings
to place the
. To exit the activated
. Below right, the
 89
GB

Publicité

Table des Matières
loading

Table des Matières