General Notes On Safety And Warnings; Scope Of Delivery; Technical Data; First Operation - Thomashilfen ThevoChair Manuel D'utilisation

General notes on safety and warnings

Please do not expose your ThevoChair to excessive stress. Refer to the maximal load-bearing capacity in
the technical data.
Caution: Do not insert your fingers into the rocking device.
The ThevoChair should only be placed or used on an even surface. Do not use the ThevoChair in places where it will
be exposed to water or high temperatures. Do not place heavy objects on the ThevoChair.
Do not sit or stand on the stool (accessories), as the supporting surface is sloping and there is a risk of slipping off.
Keep these instructions carefully! Only use original spare parts from the manufacturer.
Do not undo or remove any screws, unless this is given in the instructions.

Scope of Delivery

• ThevoChair
• User Manual
• Accessories [as ordered]

Technical data

ThevoChair
Height of back
Height
Breadth (width)
Depth of seat
Width of seat
Back angle
Seat height
Max. load-bearing capacity
Foot Stool (accessory)
Height (max)
Breadth
Depth
8
72 cm / 28.4"
110 cm / 43.3"
73 cm / 28.7"
47 cm / 18.5"
55 cm / 18.5"
112° / 115°
48 cm / 18.9"
140 kg / 308.6 lbs
41 cm / 16.1"
44 cm / 17.3"
44 cm / 17.3"
All manuals and user guides at all-guides.com

First operation

Necessary tools: 1 spanner SW 13 (included in delivery), 1 Allen screw SW 5 (included in delivery)
After you have unpacked the ThevoChair, you only have to connect the back rest with the anchor bar to be able to
use the ThevoChair. The necessary steps are as follows:
1. Tip the ThevoChair carefully on the side and lay it on a clean base.
2. Set up the back rest.
3. Connect the anchor bar and the bracket flap to the back rest with the enclosed screw and fasten with the
self-locking nut. Important: The thread of the screw must slightly protrude above the nut. (Fig. 1)
4. Carefully set up the ThevoChair again.
Your ThevoChair is now ready for use.

Basic Settings

Adjusting the back rest
The angle of the back rest can be set at two different positions. The factory setting is in the steeper position.
The arm rest can be tipped backwards by unlocking the anchor bar by pulling the tensile latch bolt in the middle of
the front edge of the seat. Let the latch bolt go and lock the back rest in the new position. (Fig. 2)

Accessories

We offer the following accessories for the ThevoChair:
• Foot Stool
• protective incontinence covers for ThevoChair + Foot Stool
• Cover for the foot of the chair
Attachment of the cover for the foot of the chair (accessories)
You can mount the cover for the foot of the chair as follows:
1. Tip the ThevoChair carefully on the side and lay it on a clean base.
2. Open the 4 zips of the cover.
3. Pull the cover over the foot of the chair and fasten all zips.
4. Make sure that the cover is sitting evenly.
5. Carefully set up the ThevoChair again - ready
Attachment of the protective incontinence covers (accessories)
The set contains five separate covers which can be used for the backrest, the seating surface and the side panel of the
ThevoChair as well as a cover for the surface of the footstool. We recommend using the protective covers for
extended use especially, e.g. in care communities. Please find the separate instruction enclosed at the accessories.
You can order accessories for the ThevoChair from Thomashilfen. We would be glad to advice you.
9