Responder LE VIPER 9252 Guide D'instructions page 11

that the MTS mode is properly set when parking. If MTS mode is not
properly set or is defeated after being properly set the system will not
start the engine.
1. With the engine running and transmission in NEUTRAL position,
set the parking brake and leave the engine running. All Doors
should be closed.
Release the foot brake (if pressed during Step 1), or press and
2.
release the foot brake anytime. As long as the engine is running
there is no time limit to perform this step.
3. Within 20 seconds of foot brake release,
the remote, after 20 seconds return to Step 2.
4. The vehicle lights flash 5 times to confirm MTS mode enable and
the remote start activates the ignition outputs.
5. Turn Off and remove the key from the ignition switch, the engine
remains running.
Exit the vehicle, close all the doors and lock the system.
6.
7. The engine turns off after a few seconds.
You can now remote start the vehicle. If a door is opened before
the next remote start activation, the system will not remote start the
vehicle.
To drive your automatic or manual transmission vehicle after it has
been remote started:
1. Get in without stepping on the brake.
2. Insert the ignition key and turn it to the On position.
3. Now, step on the brake. The remote start turns off.
4. The vehicle is ready to drive.
8
All manuals and user guides at all-guides.com
press the
button on
© 2009 Directed Electronics. All rights reserved.