Functional Description; Side Handle - ITC POWER TOOLS SPT145 Manuel Du Propriétaire

FUNCTIONAL DESCRIPTION

A Depressed centre grinding
disc
B Metal gear head
C Arbor lock button
D Cooling vents
E Tool support point
F Cooling vents
G Cable protector
H Slide switch
I

Side handle

J Wheel guard
K Inner flange
ASSEMbLY
!
!
!
GUARD
Your grinder comes with an adjustable wheel guard (J, fig.II). This is to allow you to
grind at various angles and still be protected to some extent from flying residue or
debris should a disc shatter in use.
If the guard needs to be installed, or if you wish to rotate the guard to provide

more protection at the angle you plan to use the grinder:
1. WARNING- Be sure the tool is switched off and unplugged.
2. Loosen the clamping screw (a, fig.II) on the collar
3. Locate the guard collar onto the tool or rotate the guard to give you protection
and expose the disc on the appropriate side.
4. Tighten the screw to clamp the guard in place.
CAUTION- Do not use this tool with the guard removed.
SIDE HANDLE
The auxiliary side handle (I, fig.III) for your grinder may be fitted to either the left or
right side of the unit. Select the position which provides the most comfortable and
safe use.
1. WARNING- Be sure the tool is switched off and unplugged.
Page 5 of 24
®
v.081124