ITC POWER TOOLS SCMS10UD Manuel De L'utilisateur page 3

IMPORTANT SAFETY INSTRUCTIONS
15. USE EYE PROTECTION. Use a full-face mask if the work you're doing
16. SECURE WORK. Use clamps or a vise to hold the work. It's safer than using
17. DON'T OVERREACH. Keep proper footing and balance at all times. Do not
18. MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better and
19. AVOID UNINTENTIONAL STARTING. Be sure the switch is in the OFF
20. ALWAYS CHECK AND MAKE SURE TO REMOVE ANY ADJUSTING KEYS
21. DO NOT USE THE TOOL IF IT CANNOT BE SWITCHED ON OR OFF. Have
22. DISCONNNECT THE PLUG FROM POWER BEFORE MAKING ANY
23. STAY ALERT. Watch what you are doing & use common sense. Don't operate
24. CHECK FOR DAMAGED PARTS. Before using this tool, any part that is
25. REPLACEMENT PARTS. When servicing, use only identical replacement
26. SERVICE AND REPAIRS should be made by qualified repair technicians at an
SPECIFIC SAFETY PRECAUTIONS FOR THIS TOOL
WOOD ONLY. This tool is designed for woodcutting only.

DAMAGED OR WARPED SAW BLADES should not be used. They are out

USE ONLY WITH GUARD IN PLACE. The guard protects you, the operator,

REPLACE THE TABLE INSERT WHEN WORN. Excessive tear-out increases

ALWAYS USE THE BLADE WRENCH to tighten the saw blade onto the

CONNECT YOUR MITRE SAW TO A DUST COLLECTING DEVICE if

USE A SAWBLADE SUITED TO THE CUTTING JOB AND MATERIAL TO

produces metal filings, dust or wood chips. Goggles are acceptable in other
situations. Wear a clean dust mask if the work involves creating a lot of fine or
coarse dust.
your hands and it frees both hands to operate the tool.
reach over or across machines that are running.
safer performance. Follow instructions for lubricating and safe performance.
Follow instructions for lubricating and changing accessories. Keep handles dry,
clean and free from oil and grease.
position before plugging in.
OR WRENCHES before turning the tool on. Left attached, these parts can fly
off a rotating part and result in personal injury.
your tool repaired before using it.
ADJUSTMENTS. Changing attachments or accessories can be dangerous if
the tool could accidentally start.
any tool when you are tired.
damaged should be carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment of moving parts, binding
of moving parts, breakage of parts, mountings, and other conditions that may
affect its operation. Inspect screws and tighten any ones that are loose. Any
part that is damaged should be properly repaired or replaced by an authorized
service center unless otherwise indicated elsewhere in the instruction manual.
Have defective switches replaced by an authorized service center. Don't use
the tool if switch does not turn it on and off properly.
parts.
authorized repair center. Improperly repaired tools could cause serious shock
or injury
of balance and could cause further damage to the saw and possible personal
injury.
from cutting debris as well as from broken pieces of the blade if it breaks in
use.
the likelihood of injury from flying debris. When setting the saw at a new
angle, check that due to some mis-alignment, the blade does not cut into the
table insert, rear fence, or another part of your saw.
arbor.
possible. If not, use the dust bag that comes with the tool and empty it
regularly.
BE CUT.

v.081118