Tips For Saving Energy - HIGHONE TT 93 F W625C Consignes D'utilisation

B
Using the appliance
1 Remove the plastic covering from the upper door hinge.
2
Loosen the 3 screws of the lower bracket. Remove the foot from the opposite side.
3
Place it on one side.
Slide the appliance door downwards by about 15 cm, then take it off the upper
4
hinge pin and lift it up to release it from the appliance.
Remove the 2 screws from the top bracket and place them on the other side. You
5
will need to remove the plastic caps from the other side beforehand.
Slide the door of the appliance to reattach it to the upper hinge, making sure it is
the right way up. Screw the lower hinge into place on the new side. Put the other
6
foot in place on the other side. Replace the plastic cover so that it clicks into place
on the door hinge.
Make sure that the door is aligned horizontally and vertically, and that the seals
7
are closed on all sides before tightening the lower hinge. Adjust the levelling feet.
8
The appliance door must be able to open fully, as shown (W87 x H105 x D107).
To make it level, adjust the two levelling feet on the front of the appliance. If the
9
appliance is not level, the door and the magnetic seal may not be aligned.
12 EN
B
Using the appliance

Tips for saving energy

• Be careful not to open the door too frequently, especially in humid and hot weather. Close
the door as soon as possible.
• Check that the appliance is sufficiently ventilated (adequate air flow behind the appliance)
from time to time.
• Under normal temperature conditions, set the temperature control between the "Min" and
"Med" positions.
• Before placing packets of fresh food in the appliance, make sure that they have cooled down
to room temperature beforehand.
• If it is the outer condenser, the rear wall should always be cleaned so that it is free of dust
and dirt.
• Always follow the instructions in the section on "Tips for positioning and saving energy".
Otherwise, the energy consumption may be significantly higher.
• The appliance must be installed in the coolest part of the room, away from heat-producing
appliances or heating ducts, and away from direct sunlight.
• Leave hot food to cool down to room temperature before placing it in the appliance. Overloading
the appliance can make the compressor operate for longer periods.
• Be sure to wrap food items properly, and wipe containers dry before placing them in the
appliance. This will help to reduce the build-up of frost inside the appliance.
• Do not line the storage bin with aluminium foil, waxed paper or paper towels. Insulators
obstruct the flow of cold air and make the appliance less efficient.
• Organise and label food so that you don't have to open the door as often or for as long while
searching for something. Remove as much food as you need at a time, then close the door
as soon as possible.
13 EN