Installation; Power Supply - DELTA DORE DTX Notice D'installation Et D'utilisation

Installation

Open the transmitter
and mount the base.
2
Do not change the position of the microswitches.
The positions were set at the factory in the position shown
in the following diagram.
1 : universal transmitter
2 : immediate triggering
3 : type of contact
(normally closed)
- Connect the 2 wires of
the sensor to terminals 1
and 2 of the technical
detector
- Leave the wired strap
between terminals 2
and 3.
- 15 -
All manuals and user guides at all-guides.com
3
1
ON
1 2
Transmitter
Strap
(do not remove)
Sensor
(not supplied)

Power supply

Fitting or changing batteries
- Remove the battery cover.
- If the batteries need replacing, fit 2 new LR03 type (or AAA)
alkaline batteries, same source and same date, ensuring
that the polarities are correct.
3
- Close the cover.
Never throw away flat batteries. They must be taken back to
the point of purchase.
Flat battery indication
A series of 3 short beeps each time a radio message is
emitted.
2 batteries
type LR03
(or AAA)
The technical detector
must emit 2 beeps,
otherwise check the
battery polarities.
- 16 -