Speed Controller „Guec Ge-602; Performance Characteristics - GAUI X4 Combo Notice D'emploi

12. Speed Controller „GUEC GE-602"
Before taking the speed controller into operation, read the notes on operation and programming carefully.

Performance Characteristics

• Compatible with lithium and nickel rechargeable batteries (LiIon-, LiPo- and NiMH-, NiCd-batteries)
• Extremely low internal resistance for the lowest possible voltage drop.
• Protective switching for undervoltage, overheating and RC signal loss
• 3 different start modes: Normal, soft, very soft for direct or gear drives
• Configurable throttle range for all transmitters on the market
• Straight-lined and quick throttle acceptance
• Microprocessor with separate voltage controller for best interference supposition
• Max. speed 210000 rpm (for 2-pin motors), 70000 rpm (6-pin), 35000 rpm (12-pin)
• Programming via programming card or transmitter possible
Programmable Settings
1. Brake function:
Off / On (standard setting: off)
2. Rechargeable battery type:
Lithium (LiIo- or LiPo-batteries) / NiCd-/NiMH-batteries (standard setting: Lithium)
3. Cut-off mode:
Soft = step-by-step decrease of the output performance / hard = immediate switch-off of the output performance
(default setting: soft)
4. Cut-off switching threshold:
Low / medium / high (default setting: medium)
For Lithium batteries, the values correspond to 2.6 / 2.85 V / 3.1 V per cell.
For NiMH batteries, the values correspond to 0% / 45% / 60% of the starting voltage.
5. Start mode:
Normal / soft / very soft (default setting: very soft)
The setting „normal" is recommended for flight models with direct drive.
The settings „soft" with 1 s start-up time and „very soft" with approx. 2 s start-up time are mainly suitable for flight
models with gear motors and helicopter models.
If the motor is switched off after starting and full throttle is activated again within 3 seconds, the controller briefly
switches from „soft" or „very soft" to „normal" to prevent danger of damage to the model from the delayed throttle
acceptance.
6. Timing:
Low / medium / high (default setting: low)
Usually, low timing values are sufficient for most motors. For 2-pole motors, we recommend the setting „low"; for 6- or
more-pole motors, we recommend the setting „medium". Since there are very many different motors on the market,
you should determine the best timing value for your own. Usually, slightly higher timing values will also provide slightly
more performance; at the same time, however, it increases power consumption and thermal load of the motor, controller
and battery.
34
All manuals and user guides at all-guides.com