Incorrect Assembly; Disposal And Waste Prevention; Our Contribution To Protecting The Ozone Layer; Waste Prevention - Konifera BW73000SKD Instructions De Montage

Incorrect assembly

Problem Possible cause
The awning frame is The canopy pole is not
at an angle. horizontal.
The feet are not
vertical.
The plastic clamps
are not vertical to the
canopy pole and/or not
vertical to the feet
The awning canopy The upper seam of the
is not tightened awning canopy is not
tightly stretched in the
canopy pole.
The awning frame is at
an angle.

Disposal and waste prevention

Our contribution to protecting
the ozone layer
Our packaging is made of environ-
mentally friendly, recyclable materi-
als:
– Outer packaging made of cardboard
– Moulded parts made of foamed, CFC-free
polystyrene (PS)
– Films and bags made of polyethylene (PE)
– Tension bands made of polypropylene (PP)
If you would like to dispose of the packag-
ing, please dispose of it in an environmentally
friendly way.
Incorrect assembly
Solutions, tips, explanation
Loosen the plastic clamps and change the
position of the canopy pole (see "Awning
frame" on page EN-6).
Adjust the feet and the extension pole (see
"Awning frame" on page EN-6).
Loosen the plastic clamps and make sure
they are perpendicular to the feet (see
"Awning frame" on page EN-6).
Tighten the awning canopy tightly in the
canopy pole (see "Awning canopy" on
page EN-6)
Straighten the awning frame (see "Awning
frame" on page EN-6).

Waste prevention

According to the provisions of Directive
2008/98 EC, waste prevention measures al-
ways take priority over waste management.
Waste prevention measures include repairing
and reselling used working products instead
of disposing of them.
Please help us reduce waste and contact our
Service department if your product is faulty.
More information can be found in the bro-
chure 'Waste Prevention Programme - of the
German Government with the Involvement of
the Federal Länder'.
Page EN-9