Stealth Cam STC-DS4KMAX Mode D'emploi page 16

Using the UP and DOWN arrows will allow the setting to be change from 00 to 59. Again when this setting is on the
appropriate minute, press the RIGHT arrow key to move to the AP (am/pm) setting and it will start to blink. Using the
UP and DOWN arrows will allow the setting to be changed from AM to PM.
TL START – 06:00PM (default): This setting is used to give the camera the start time for when to start the
"
time---lapse photography. The default format is in a HH/MM/AP setup, should the time format be in 24 hour
the format it will show HH/MM. With the HH (hour) setting blinking, use the UP and DOWN arrows to allow the
setting to be changed from 1 to 12. Once this setting is on the appropriate hour, press the RIGHT arrow key to
move to the MM (minute) setting and it will start to blink.
TL STOP – 08:00AM (default): This setting is used to give the camera the stop time for when to end the time-
"
lapse photography. The default format is in a HH/MM/AP setup, should the time format be in 24 hour the
format will be HH/MM. With the HH (hour) setting to blinking, use the UP and DOWN arrows to allow the
setting to be changed from 1 to 12. Once this setting is on the appropriate hour, press the RIGHT
arrow key to move to the MM (minute) setting and it will start to blink. Using the UP and DOWN arrows will
allow the setting to be change from 00 to 59. Again when this setting is on the appropriate minute,
press the RIGHT arrow key to move to the AP (am/pm) setting and it will start to blink. Using the UP and
DOWN arrows will allow the setting to be changed from AM to PM.
REDUCE BLUR – ADVANCED (default): This is used to determine if the camera should use the MATRIX
"
Blur reduction technology to dramatically reduce the blur effect resulting in clearer night time infrared shots.
(STANDARD) Minimizes blurring effect in images while retaining long-range night image capability.
(ADVANCED) Maximum blur reduction achieved through a faster shutter speed. This setting my cause a
slight reduction in night time range and increased grain in the image. With this option blinking, pressing the UP
or DOWN arrow buttons will cause the camera to cycle between the two options of STANDARD or ADVANCED.
EXAMPLE: Data Stamping on the bottom portion of the picture indicates the camera took a picture in
Time Lapse (TL) mode.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
16
Page