Stealth Cam STC-DS4KMAX Mode D'emploi page 11

PIR PHOTO (default): In this mode the camera will take a designated amount of picture with a
o
designated time out when the camera senses activity in front of the unit. This mode adjusts
for both day and night activities.
PHOTO DAY PHOTO RES – 8.0 (default): This setting is used to determine the Megapixel resolution of
"
each image taken by the camera. With this option blinking, use the UP or DOWN arrow key to move
between the options of: 32MP, 16MP, 8MP, 4MP Day resolutions The higher the resolution of an
image the more space the fie will take on the SD memory card.
NIGHT PHOTO RES – 6.0 (default): This setting is used to determine the Megapixel resolution of each
"
image taken by the camera. With this option blinking, use the UP or DOWN arrow key to move
between the options of: 14MP, 8MP, 6MP, 2MP Night resolutions The higher the resolution of an
image the more space the fie will take on the SD memory card.
PIR DELAY – 00min 05sec (default): This setting is used to determine the length of the time that the
"
camera will wait before it reinitializes its PIR sensor for the next activation. With the TL mode this
setting is only active if TL Delay is set to 1 min or greater. This setting can be changed between the
numbers of 00min 05sec to 59min 59sec. With this option blinking, use of the UP and DOWN
arrows will allow the minutes setting to be changed from 00 to 59. Once this setting is on the
appropriate minutes, press the RIGHT arrow key to move to the seconds setting and it will start to
blink. Use of the UP and Down arrows will allow the seconds setting to be changed from 00 to 59 (05
to 59 if minutes = 00).
"
PIR RANGE – STANDARD (default): This setting allows you to control the sensitivity distance the PIR
will be activated. These distances can vary depending on environmental conditions. This setting will
change between EXTENDED which will trigger about 1/3 further than the STANDARD setting, the
STANDARD setting, or NEAR FIELD that will only trigger on movement closest to the camera.
IR Brightness Control – FULL (default): This setting is used to adjust the brightness of the IR LEDS.
"
With this option blinking, use the UP or DOWN arrow key to move between FULL and HALF brightness.
On FULL brightness the LEDs have a further flash range making it ideal for large open areas. HALF
brightness is ideal for close up shots preventing the subject from being overexposed.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING -­‐ CUSTOM (CONT)
11
Page