cecotec BigDry 2000 Light Manuel D'instructions page 6

ENGLISH
1. SAFETY INSTRUCTIONS
Read these instructions thoroughly before using the appliance.
Keep this instruction manual for future reference or new users.
Make sure that the mains voltage matches the voltage
•
stated on the rating label of the appliance and that the wall
outlet is grounded.
Check the power cord regularly for visible damage. If the
•
cord is damaged, it must be replaced by the official Technical
Support Service of Cecotec, in order to avoid any type of
danger.
To avoid electric shocks, do not clean with or allow to get
•
inside the product: water, liquid or any flammable substance.
• Do not immerse the cord, plug, or any non-removable part
of the appliance in water or any other liquid, nor expose the
electrical connections to water. Make sure your hands are
dry before handling the plug or switching on the appliance.
• The appliance shall be installed, operated and stored in a
room with a floor area larger than 4 m2.
• Switch off the device immediately in the event of defects or
malfunctions.
• Do not use the device if its cord or any other part is damaged.
In this case, contact the official Technical Support Service of
Cecotec.
Do not spray insecticide, perfume or other flammable
•
substances around the product. Do not operate the device
with products with odours.
• Do not install the device near to heat-generating appliances
or flammable and dangerous materials.
• This product does not replace normal ventilation products.
Make sure the product is kept and stored in well-ventilated
•
areas.
During operation, leave at least a 20-cm space on the back
•
and sides of the product.
6 BIGDRY 2000 LIGHT | BIGDRY 2000 LIGHT BLACK