Before Use; Cleaning And Maintenance - cecotec BigDry 2000 Light Manuel D'instructions

3. BEFORE USE

Take the product out of the box and remove all packaging material.
•
Make sure all parts and components are included and in good conditions. If any visible
•
signs of damage are observed, contact the Technical Support Service immediately.
Always keep the dehumidifier in an upright position to avoid leakages.
•
4. OPERATION
Connect the power adapter to the dehumidifier and then plug it into a power socket.
1.
Press the on/off button (1) to turn the unit on, the LED power indicator will light up blue.
2.
Press the on/off (1) button again to switch the device off, the LED power indicator should
3.
turn off.
Press and hold the on/off (1) button for 3 seconds to turn the LED indicator off.
4.
Press and hold the on/off (1) button for 3 seconds to turn the LED indicator back on.
5.
6. This unit has a de-frosting function. If the unit detects frost on the surface of the cooling
plate, it will stop dehumidifying. After de-frosting, the unit will automatically continue to
dehumidify.
Draining collected water
The water tank in this unit has a maximum capacity of 600 ml, with a 300 ml per day
1.
working capacity.
The LED indicator will turn red once the water tank is full and the unit will automatically
2.
turn off.
3. Disconnect the power cable from the unit.
When the water tank is full, avoid tilting it and carefully pull it out, slide the water tank
4.
cover and pour the water out.
Insert the cover and then insert the water tank back into the unit and press the on/off
5.
button to resume operation.

5. CLEANING AND MAINTENANCE

Make sure the unit is powered off and that the power cable is disconnected from the
1.
power source.
2. Use a soft cloth to clean away any dust or debris from the surface of the unit or the air
inlets.
Pull out the water tank and slide out the cover to clean the water tank.
3.
BIGDRY 2000 LIGHT | BIGDRY 2000 LIGHT BLACK
ENGLISH
27