Global Industrial 318511 Manuel D'instruction page 3

USING AUTOMATIC FEED
1. Turn sensor switch ON.
2. Tape will be fed set length and cut.
3. Remove a piece of tape from machine.
4. Another piece will be fed and cut.
USING MANUAL FEED
1. Turn sensor switch OFF.
2. Press "AUTO" and the set length of tape
will be fed and cut.
CHANGING TAPE
1. Turn sensor switch OFF.
2. Press to reverse tape. The feed roller
will rewind the tape away from cutting
area.
3. Remove the whole reel from unit and
replace tape.
HOW TO REMOVE JAMMED TAPE
1. Press to revers tape.
a. Hold the tape and wind it backward.
2. Remove tape from metal roller.
3. Cut wrinkled part of tape.
IN CASE OF HEAVY TAPE JAM
1. Remove cutting head from the unit.
2. Cut wrinkled part of tape.
3. Remove jammed tape with tweezers.
a. Cut any tape wrapped around rollers
with scissors. Use caution to avoid
damaging rollers.
Make sure to unplug power cord to avoid injury. DO NOT touch cutter blade!
WARNING:
All manuals and user guides at all-guides.com
AUTO TAPE DISPENSER M-1000
ELECTRIC TAPE DISPENSER 318511
Remove a
Piece of Tape
Press "Auto Key"
Turn Sensor
Switch "OFF"
IF TAPE IS JAMMED IN THE CUTTING HEAD
1. Remove cutting head from the unit.
2. Check the gap of the blade on the back.
3. Remove jammed tape with tweezers.
a. If heavily jammed, cutter spring needs
to be removed. See details in the next
section.
3
Automatically
Set Length Is
fed and Cut
Wind Tape
Backward Slightly