Global Industrial 318511 Manuel D'instruction page 2

OPERATION
Make sure power and sensor
WARNING:
switches are OFF for safety.
1. Plug sensor plug into the unit.
2. Plug power cord in.
3. Turn the power switch ON.
4. Min. set length of 20 will be shown on
the LED display.
LOADING TAPE
1. Remove the reel from the unit.
2. Load tape on the reel and place it back
into the unit.
3. Make sure to position the tape on the
center of the reel.
4. Fold corners of the tape to form a
trapezoid shape.
5. Stick the tape onto the metal feed roller.
6. Press until tape feeds through cutting
head.
7. Adjust "Pressure knob" in accordance
with tape.
a. If tape curls up or slips, increase
pressure. (Turn Clockwise)
b. If tape creases, decrease pressure.
(Turn Counter-clockwise)
8. Advance 3cm – 4cm of the tape out from
the cutting head.
9. Press to cut the tape and remove.
SETTING TAPE LENGTH
1. Make sure sensor switch is OFF.
2. Press "mm" and "cm" for setting
length.
a. Press "mm" to set length of
0-9mm (last digit)
b. Press "cm" to set length of
20-990mm
3. Keep pressing button for quick
change.
4. Last setting length is saved even
when main power is turned OFF.
All manuals and user guides at all-guides.com
AUTO TAPE DISPENSER M-1000
ELECTRIC TAPE DISPENSER 318511
LED Display
Fold Tape Back
Feed Roller
Remove Tape
RESETTING SAVED LENGTH
1. Press "20" to reset and back to min
set length of 20mm.
Make Sure Sensor
Switch Is OFF
2
Instruction Manual
Turn OFF
Cut Key