Vacuuming Dry Materials; Vacuuming Liquids - Kawasaki 692358 Manuel De L'utilisateur

VACUUMING DRY MATERIALS

1. Verify that the power cord is disconnected
from the outlet.
2. Make sure the cartridge filter is clean and
dry and properly installed over the filter
basket. The cartridge filter must always be
in the correct position at all times to avoid
leaks and possible damage to vac.
3. Insert the collection filter bag into
the tank and fit the dust bag flange
onto the inlet stub taking care not to
damage the bag.
4. Reinstall the powerhead onto the
tank and latch into place.
5. Attach the vacuum hose to the vac-
uum port on the side of the tank.
Attach the required attachment noz-
zles onto the vacuum hose nozzle.
6. Plug the power cord into the outlet.
7. Set the power switch to ON (position I).
8. Place the face of the attachment nozzle flat against the surface to be cleaned
and start vacuuming by slowly moving the attachment nozzle back and forth.
You may change the air suction power by adjusting the hatch over the air flow
control opening located on the top of the vacuum hose nozzle.
9. When you have finished vacuuming, press the switch to "OFF" (position 0) and
unplug from the outlet.
A dry filter is necessary to pick up dry material. If you use your vac to pick up
dust when the filter is wet, the filter will clog quickly and be very difficult to clean.
If your filter is wet but you need to use the vac to pick up dry material, you can
quickly dry the filter by running the vac without the hose attached for about 10
minutes. The clean air rushing through the vac will help dry the filter.
When using your vac to pick up fine dust, it will be necessary for you to empty
the tank and clean the cartridge filter at more frequent intervals to maintain peak
vac performance.
All manuals and user guides at all-guides.com
POSITION I -
ON
POSITION 0 -
OFF
AIR FLOW
CONTROL HATCH
ATTACHMENT
NOZZLE
11
Check the collection filter bag regularly and dispose of
it safely when the bag is 2/3 full. The collection filter bag is manufactured so
that only air will pass through the paper. The collection filter bag must not be
reused.
Do not use the collection filter bag for wet or sharp
materials.

VACUUMING LIQUIDS

1. Verify that the power cord is
disconnected from the outlet.
2. Release the locking latches and
remove the powerhead from
the tank and set aside. Make
sure the tank is clean and free
from dust and dirt.
3. Remove collection filter bag,
if it is already installed. Make
sure cartridge filter is installed.
Reinstall the powerhead and
latch securely to the tank.
4. Attach the vacuum hose to the vacuum port.
5. For your application, attach the desired
accessories (extension wands, floor
nozzle or multipurpose nozzle) to the
vacuum hose. Make sure air flow control
hatch on the hose nozzle is fully closed.
6. Connect the vacuum to the power. Turn on
the power switch on the vacuum power-
head and start vacuuming the liquid.
7. To vacuum large amount of water quickly,
do not attach any nozzle. See lower picture.
AIR FLOW CONTROL HATCH
12