Starting And Stopping - Sandrigarden BT 1238 CS Instructions De Service

GB
RECOMMENDED OiL
top-quality oil for two-stroke engines:
Service class JASO: FC class
W a r n i n g ! U s i n g o i l o f l o w e r
q u a l i t y t h a n t h e t y p e a b o v e
recommended,couldseriously dama-
ge the engine.
2) Mix by shaking the fuel con-
tainer extensively before each
refuelling.
Prepare a quantity of fuel that can be used
within 1 month
3) Prepare the fuel mixture and perform the refuel-
ling only in the open air (Fig.23).
4) Store the fuel in a container made for the pur-
pose and with the cap properly closed.
6. CHAiN OiL tOP UP
1) AttENtiON! Top up only with a specific oil for
lubricating chainsaw chains (see Fig.24).
2) DO NOt use waste oil.
3) An oil other than that recommended may result
in damage to the bar, to the chain and to the
lubrication system.
44
All manuals and user guides at all-guides.com
CHAiN SAW OPERAtiNG MANUAL
Fig.23
top up the chain oil tank every time you add
fuel.
Fig.24

7. StARtiNG AND StOPPiNG

AttENtiON! Comply scrupulously
with the warnings given in Section
2 above "FUNDAMENtAL SAFEtY
PRECAUtiONS".
WARNiNG! Only start the chain saw
when this is fully assembled and com-
plete with bar and chain.
7.1 StARtiNG WitH tHE ENGiNE COLD
Before start-up, make sure that the chain brake
is disconnected by pulling the lever (Fig.25)
towards the front handle.
Fig. 25
StOP