Device Description; Device Operation; Cleaning And Maintenance; Technical Data - Adler europe AD 4070 Mode D'emploi

16. Do not insert fingers or any other objects into blender's cup when the blender is on.
17. In order to avoid injuries handle the blades carefully.
18. Watch out for long hair, scarves, neckties hanging above the cup and operating
components of device.
19. For safety reasons use only original accessories and spare parts intended for particular
blender type, available at authorised service centre.
20. Handle the blades with extreme care while disassembling accessories. The blades can
cause cuts.
21. Do not wash any blender parts in dishwashers.
22. Change the accessories only when the device is switched off. Disconnect the device
from the power.
23. Do not put any products other than food and liquids in the blender cup. Do not put hot
products in the cup.
24. The device is not suitable for whipping egg whites, kneading dough or grinding meat.
Don't use aggressive detergents to clean the housing, as it may remove the informational
graphic symbols such as: scale, signs, safety marks, etc.
25. Do not start the empty mixing cup, without product inside.
26. MAXIMUM PERIOD OF CONTINUOUS BLENDER OPERATION IS 3 MINUTES. After
3 minutes of continuous operation stop the device and wait couple of minutes before
restarting.

DEVICE DESCRIPTION

1A – plug
1C – blender cup
1E – speed adjustment knob
1G – base

DEVICE OPERATION

Before first use:
1.Remove all stickers from the housing, cup and cover of the blender.
2.Wash the blender cup in warm water with washing-up liquid, rinse thoroughly, dry the inside and outside of the cup.
Blender operation:
1.Put the blender main body (1D) on stable, level surface.
2.Make sure the speed adjustment knob (1E) is set to the Off position.
3.Place the blender cup (1C) on the body (1D).
4.Remove cover (1B) from the blender cup (1C), put in the ingredients to be mixed. In order to avoid overflow, the level of ingredients in
the cup should not exceed ¾ of cup's height.
5.Connect the power plug to the power outlet.
6.Turn the blender on by pressing Pulse button or by rotating speed adjustment knob (1E) to slower speed or faster speed.
NOTICE: During mixing always hold cup (1C) with hand.
7.After the mixed products have proper consistence, turn the blender off by rotating speed adjustment knob (1E) to off position. Wait until
the blades stop. Remove the power plug from the power outlet. Remove the cup.
NOTICE: Do not allow continuous operation of blender for longer than 3 minutes.
NOTICE: The pulsation operation mode, when the Pulse setting is switched, is used for a momentary mixing with maximum speed.

CLEANING AND MAINTENANCE

Make sure that the blender is disconnected from the power.
1. Wash the cup, cover and blades in water with washing-up liquid. In order to wash the cup thoroughly put some water with washing-up
liquid in the cup, connect the blender to the power, and operate it for a short period of time in pulse mode. Then pour out the water, rinse
thoroughly and dry.
2. Clean the stained body (1D) with moist cloth, and then wipe dry.
NOTICE: Don't immerse blender body in water or other liquids.
NOTICE: Do not wash any blender parts in dishwashers.

TECHNICAL DATA

Power: 600W max 800W
1B – cover
1D – body
1F – Pulse
4