Connect The Power Cable To The Camera - Axis Communications HOV Housing VT Guide D'installation

Page 8
5

Connect the power cable to the camera

1. Using the small flathead screw driver, loosen the screws in the Power to camera
connector on the connector board (fig.4).
2. Insert the red (+) and black (GND)
wires in the connector and tighten
the screws to secure the wires.
3. Connect the wires to the green
terminal connector on the Axis
network camera (fig.5).
Note:
The camera models have different terminal connectors, be sure to follow the correct
description for the installed camera.
FIG. 5
AXIS 211/211A/211M/211W
AXIS 210/210A
Red/black power cable
+ / GND Wire
+ Red
GND Black
FIG.4
AXIS 221
+
GND
GND
AXIS 223M
+
GND
Connector board
DC Power (+)
GND
AXIS HOV Housing VT
1 2 3 4 5 6 7 8 9 10
RESET
PWR NET
POWER
AC AC
GND DC+ RS-232
+
Camera
Camera DC Power (+)
Camera (GND)
Power to
camera
GND
+
NETWORK / POWER
+
GND