Télécharger Imprimer la page

Slackers NINJALINE SLA.788M Mode D'emploi page 4

Publicité

Les langues disponibles

Les langues disponibles

TIGHTENING THE NINJALINE™
• Make sure that the ratchet is positioned so that the handle is facing down and the ratchet is fully open (open slot
on axle should be facing up). Then, feed the end of the Slackline through the top of the ratchet (Figure 5).
• Taking up ALL the slack, make sure that the line is not twisted. YOU MUST PULL THE LINE TIGHT BEFORE
USING THE RATCHET (Figure 6).
• Once line is pulled tight, start ratcheting by moving the handle back and forth until you cannot pull any tighter and
the handle is stationary. The ratchet should be underneath the line when complete, and your line should be tight
(Figure 7).
Figure 5
Figure 6
Figure 7
MANDATORY LOAD STRESS TEST
Step 1: Make sure all your connections are tight (see step 4)
Step 2: MANDATORY LOAD STRESS TEST YOUR LINE. Using either a 250 Lbs (113 Kg) weight or person, have
them test the NINJALINE™ by suspending the weight 5 ft. (1.5 m) from each end of the line.
RELEASING THE RATCHET
• To release the ratchet, pull up the vinyl coated gate inside the ratchet handle and open all the way until flat.
EXPECT A "POP"
• The second release gate should open, releasing the spool and the line tension should "pop" open with webbing
releasing (Figure 8).
• Continue to pull on the line until there is little tension left. Slide the remaining line out of the ratchet.
• Troubleshooting: If you ratchet too much of your line, you may experience difficulty releasing the line. Do your
best to lay the ratchet open and completely flat. If you cannot lay the ratchet flat, try pulling the gate and the spring
loaded piece on the opposite side of the gate at the same time, pulling in opposite directions (Figure 9). You may
need another person to help free the line while you hold the ratchet open. If this does not work, try leaving the
ratchet all the way open for several hours (overnight if possible), sometimes gravity and the weight of the ratchet
will allow the line to release naturally. If still experiencing difficulty removing your line from the ratchet, please call
customer service at 1-844-834-4334.
Figure 8
Figure 9
b4Adventure • Denver Colorado 80216 • 1-844-834-4334 • info@b4adventure.com
www.b4adventure.com - DC:082919
4

Publicité

loading

Produits Connexes pour Slackers NINJALINE SLA.788M