Table des Matières
Publicité
Step 5:
Lift up the frame on one side and insert leg tube
into the T-tube. Repeat this step to connect all
legs. Note: connect with two or more persons.
Step 7:
Put the beginning and end overlap together. The
hook goesthrough 6pcs elastic mesh only at this
place. Lay the jumping mat inside the frame.
Ensure that bounce mat faces upwards with the
logo facing where entrance will be positioned.
Manual – Trampoline – Senz Sports – J5000 Series – SZTR
Step 6:
To prepare the bounce mat to be attached to the
trampoline you must first attach the steel hooks.
Each hook connects through 3 loops of the
bounce mat. You can find blue dots on the
bounce mat, choose one blue dot as the start
point to connect the hooks. Working to the left or
right of the start section you connect the hooks
by pushing through 3 elasticated hoops on the
bounce mat mesh. Hold the hook with the round
hook section facing towards you and the hook
facing down. Then thread the loop downwards
through the first hoop, upwards through the
second and then finally downwards through the
third loop. All hoops should now be connected
over the bar of the hook.
Step 8:
Attach the steel hook to the frame tube. Choose
one steel hook which is next to the blue dot,
attach it to the holes of the frame tube beside
corresponding T- tube connector by hook
loading tool. Make sure the blue dot faces the T-
tube connector. Repeat to attach steel hooks
beside each T connector by counting the number
of steel hooks and corresponding holes on frame
tube
7
Publicité
Table des Matières
