Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Operation
Place the heater on a flat level surface and ensure that the air intake and air
1.
outlet are clear of obstruction.
Insert the plug into a 220V-50Hz power outlet.
2.
3.
Move the ON/OFF SWITCH at the rear of the unit to the on (I) position.
Press the POWER button on the control panel to turn the heater on.
4.
5.
Press the MODE button to adjust the work mode. It default to H for 1500 W,
press it to change to L for 1200 W. The LED lamps show in Red.
6.
The PTC will stop working when the thermostat temperature setting(28 °C for
H MODE and 20°C for L MODE) is reached. It will come back for working when
the room temperature is below the thermostat setting.
7.
Press SWING button to turn on/off oscillation.
Press the TIMER button to set up the timer hours as below:
8.
1hour, lamp 1
2 hours, lamp 2 on
3 hours, lamp 3 on
4 hours, lamp 1 and lamp 3 on
5 hours, lamp 2 and lamp 3 on
6 hours, lamp1, 2 and lamp 3 on.
Press the MODE button again in L mode of heat mode to activate FAN MODE,
9.
then the H LED lamp will be on and show in blue. Press mode button once
again to set the fan model to be in M and L mode.
Move the ON/OFF SWITCH at the rear of the unit to the off position (O). Turn
10.
the power off and disconnect the plug from the power outlet when not in use.
Care and cleaning
CAUTION: Disconnect power cord before servicing.
1.
Ensure that the heater is turned off (the switch on the back of the unit should
be in the offposition) .Unplug the power cord from the wall outlet before clea-
ning.
2.
Carefully wipe the exterior of the heater with a soft, damp (not wet) cloth and
All manuals and user guides at all-guides.com
6
Publicité
Table des Matières
