Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
B.
Select a suitable location for the camera. Install the camera stand
or mounting bracket in the selected location using a suitable
fastener. The camera stand or mounting bracket must be attached
to a structural object, such as a wall stud or ceiling rafter, that
supports the weight of the camera and mount.
C. The KC4300E Camera has a camera mounting block attached to
the bottom of the camera housing. The ¼"-20 UNC threaded
mounting hole attaches to the bolt on the camera stand or
mounting bracket.
D. The two screws on the camera mounting block allow the block to
be removed and repositioned on top of the camera housing.
E.
NOTE: Do not aim or point the camera towards the sun or into a
strong light.
F.
Attach a CS-mount lens directly to the front of the camera. If a C-
mount is used, attach the CS/C lens adapter before attaching the
C-mount.
G. Connect a video coaxial cable from the VIDEO OUT connector on
the back of the KC-4300 camera to the input port of the monitor.
H. Wire the 230V ac power supply to the green ac power connector
on the back of the camera. Use only a UL listed Class 2 power
transformer.
I.
Apply 230V ac power to the camera. The power LED on the back
of the camera illuminates and remains illuminated as long as
power is applied to the camera.
J.
Adjust the lens focus and iris controls for an optimum picture.
1.3
MANUAL IRIS LENS ADJUSTMENT
When using the Manual Iris lens, turn the Iris to the ON position and
adjust the manual iris for the appropriate range. Adjust during the
brightest conditions, opening the lens without saturating the picture. Set
the EI switch to ON. Adjust the lens opening for the minimum F-number
yielding a good picture under the brightest scene conditions.
The Manual Iris is used in indoor applications where lighting from
windows can considerably affect the light level of the room.
1.4
VIDEO TYPE AUTO IRIS LENS INSTALLATION AND ADJUSTMENT
The KC4300E Camera supports video-type auto iris lenses to adjust for
changing light levels. Perform the following steps to install and adjust a
video-type auto iris lens.
A.
Thread the video-type auto iris lens on to the lens mount.
B.
Connect the lens control wiring to the three position terminal block
on the back of the camera. The following diagram illustrates the Pin
connections. Red, white, and black are the most common colors
used for wiring on video-type auto iris lens.
All manuals and user guides at all-guides.com
English
7
Publicité
Table des Matières
