Beha-Amprobe AT-8000-EUR Serie Manuel De L'utilisateur page 12

2. KIT COMPONENTS
2.2 AT-8000-TE Transmitter
The AT-8000-TE Transmitter works on Energized and De-energized circuits up to 600 V AC/DC
in Category I through Category IV electrical environments.
VOLTAGE WARNING
INDICATOR
1. Red: Energized
2. Off: De-energized
3. Blinking: Overvoltage
VOLUME
ADJUSTMENT
BUTTON (+/-)
LOOP MODE INDICATOR
RUBBER OVERMOLDED
ENCLOSURE
POWER BUTTON
ON/OFF: Short press to turn the Transmitter on. Long press >2s to turn the Transmitter off.
Volume adjustment: The volume can be changed by short presses on VOLUME UP/DOWN
buttons. In addition to mute, four volume levels are available. The chosen volume level will
be shown on LED display for a short time. If sound is muted, the MUTE LED light will be on.
The sound pattern is different depending on chosen operating mode.
Voltage Warning indicator: The warning light will be ON for Energized circuits (30 to 600 V
AC/DC), OFF for De-energized circuits (0 > 30 V AC/DC), and BLINKING if an overvoltage is
detected (> 650 V AC/DC).
TRANSMISSION MODE INDICATOR: The LEDs will blink with different rhythm depending on the
chosen operating mode.
Transmitting in HIGH mode – Fast blinking
Transmitting in LOW mode – Slow blinking
Transmitting in LOOP mode – Alternating blinking
High mode: Short press on HI to turn on HIGH transmitting mode. Second short press on HI
button to turn off transmitting.
Low mode: Short press on LO to turn on LOW transmitting mode. Second short press on LO
button to turn off transmitting.
Loop mode: Long press (>2s) on HI to turn on Loop mode. Short or long press on HI button
to turn off Loop mode.
Figure 2.3: Overview of AT-8000-TE Transmitter
AT-8000-TE
TRANSMITTER
HI
LO
8
TRANSMISSION MODE
INDICATOR
MUTE INDICATOR
HIGH SIGNAL MODE
Press >2s for Loop mode
LOW SIGNAL
(PRECISION) MODE
BATTERY STATUS